TCP/IP Configuration and Management Manual

Configuring the NonStop TCP/IP Subsystem
TCP/IP Configuration and Management Manual—427132-004
3-25
Configuration 3: Startup Files for Two Hosts Using
an X25AM-Based Connection

The TELSERV process name is $ZTN2.

In TCPSUBU2:

The SUBNET added specifies the device name $X25A and IP address
128.30.224.12

The LISTNER process name is $LSN2.

The ADDRMAP entry (#A2) has an IPADDRESS specification of 128.30.224.11
and an X121ADDR specification of 00000011300000.
UP2: The Main Command File
The command file UP2 acts as the root command file and invokes all the second-level
subordinate command files.
Also included is a set of command files to take the subsystems down. Carefully
examine each of these command files and verify the differences just listed.
Example 3-11 shows a listing of the command file for UP2:
X25SUBU2
The command file X25SUBU2 sets the line attributes and adds SUs for the line $X25A.
Example 3-12
shows a listing of the command file for X25SUBU2:
Example 3-11. Main Up File for X.25
== TACL command file to bring up TCP/IP over X25 for \NY.
== Set default volume and subvolume
Volume $CB21.TCPIPX25
== Add and start PDN X25 subdevices
scf/in X25SUBU2/
delay 10 sec
== Start a TCP/IP Subsystem.
command tcpup2
== Status everything
scf/in status2/