TCP/IP Management Programming Manual

Commands and Responses
HP NonStop TCP/IP Management Programming Manual—529636-001
6-44
LISTOBJECTS Command
ZCOM-TKN-OBJNAME
specifies the name of a TCP/IP object being listed by the command. Unless there
is an error that prevents the LISTOBJECTS command from being attempted at all,
this token is present in every response record. There can be multiple
ZCOM-TKN-OBJNAME tokens in a single response record.
ZCOM-TKN-OBJNAME is described in Data Communications Standard Definitions
on page 5-9.
ZCOM-TKN-OBJTYPE
specifies the type of object listed. This token can have the value
ZCOM-OBJ-SUBNET, ZCOM-OBJ-ROUTE, or ZCOM-OBJ-NULL. For more
details, see Data Communications Standard Definitions on page 5-9.
ZSPI-TKN-RETCODE
specifies whether the command has been completed successfully. The value of
this token remains zero (ZCOM-ERR-OK) when the command is completed
successfully with or without a warning.
If the command is not completed successfully, the value of this token indicates the
reason the command failed. Always check the contents of the error list to
determine the token or value in error. For details on the ZCOM return codes, see
the SPI Common Extensions Manual. The possible nonzero values of RETCODE
in response to the LISTOBJECTS command are:
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-CMD-NOT-SUPP (-5)
ZSPI-TKN-ERRLIST
indicates the beginning of an error list. For more details, see SPI Standard
Definitions on page 5-1.
ZSPI-TKN-ENDLIST
indicates the end of a data list or an error list. For more details, see SPI Standard
Definitions on page 5-1.