TCP/IP Management Programming Manual

Commands and Responses
HP NonStop TCP/IP Management Programming Manual—529636-001
6-49
LISTOPENS Command
this token is present in every response record. ZCOM-TKN-OBJNAME is
described in Data Communications Standard Definitions on page 5-9.
ZCOM-TKN-OBJTYPE
specifies the type of object queried. This token has the value ZCOM-OBJ-PROC.
For more details, see Data Communications Standard Definitions on page 5-9.
ZSPI-TKN-RETCODE
specifies whether the command has been completed successfully. The value of
this token remains zero (ZCOM-ERR-OK) when the command is completed
successfully with or without a warning. Note that if the empty response (ZCOM-
ERR-EMPT-RSP) is returned, the value of this token is nonzero although the
command is completed successfully.
If the command is not completed successfully, the value of this token indicates the
reason the command failed. Always check the contents of the error list to
determine the token or value in error. For details on the ZCOM return codes, see
the SPI Common Extensions Manual.
The possible nonzero values of RETCODE in response to the LISTOPENS
command are:
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-CMD-MISMATCH (-4)
ZSPI-TKN-ERRLIST
indicates the beginning of an error list. For more details, see SPI Standard
Definitions on page 5-1.
ZSPI-TKN-ENDLIST
indicates the end of a data list or an error list. For more details, see SPI Standard
Definitions on page 5-1.