TCP/IP Management Programming Manual

Commands and Responses
HP NonStop TCP/IP Management Programming Manual—529636-001
6-69
RESETSTATS Command
ZCOM-TKN-OBJNAME is described in Data Communications Standard Definitions
on page 5-9.
ZCOM-TKN-OBJTYPE
specifies the type of object for which information was requested. For more details,
see Data Communications Standard Definitions on page 5-9.
ZSPI-TKN-RETCODE
specifies whether the command has been completed successfully. The value of
this token remains zero (ZCOM-ERR-OK) when the command is completed
successfully with or without a warning. Note that if the empty response (ZCOM-
ERR-EMPT-RSP) is returned, the value of this token is nonzero, although the
command is completed successfully.
If the command is not completed successfully, the value of this token indicates the
reason the command failed. Always check the contents of the error list to
determine the token or value in error. For details on the ZCOM return codes, see
the SPI Common Extensions Manual.
The possible nonzero values of RETCODE in response to the RESETSTATS
command are:
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-CMD-NOT-SUPP (-5)
ZSPI-TKN-ERRLIST
indicates the beginning of an error list. For more details, see SPI Standard
Definitions on page 5-1.
ZSPI-TKN-ENDLIST
indicates the end of a data list or an error list. For more details, see SPI Standard
Definitions on page 5-1.