TCP/IP Management Programming Manual

Commands and Responses
HP NonStop TCP/IP Management Programming Manual—529636-001
6-72
START Command
ZCOM-TKN-OBJNAME
specifies the name of the TCP/IP subnet or route started by the command. Unless
there is an error that prevents the START command from being attempted at all,
this token is present in every response record. If you have used an object-name
template, a separate ZCOM-TKN-OBJNAME token is returned for each subnet or
route that meets the template requirements. ZCOM-TKN-OBJNAME is described in
Data Communications Standard Definitions on page 5-9.
ZCOM-TKN-OBJTYPE
specifies the type of object started. The possible values are ZCOM-OBJ-SUBNET
and ZCOM-OBJ-ROUTE. This token is present in every response record. The
value of the ZCOM-TKN-OBJTYPE token is the same as the value of the
ZSPI-TKN-OBJECT-TYPE token in the header. For more details, see Data
Communications Standard Definitions on page 5-9.
ZSPI-TKN-RETCODE
specifies whether the command has been completed successfully. The value of
this token remains zero (ZCOM-ERR-OK) when the command is completed
successfully with or without a warning. Note that if the empty response (ZCOM-
ERR-EMPT-RSP) is returned, the value of this token is nonzero, although the
command is completed successfully.
If the command is not completed successfully, the value of this token indicates the
reason the command failed. Always check the contents of the error list to
determine the token or value in error. For details on the ZCOM return codes and
associated error lists, see the SPI Common Extensions Manual. The possible
nonzero values of RETCODE in response to the START command are:
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-OBJ-ALRDY-IN-SUMSTATE (-16)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-CMD-NOT-SUPP (-5)