TCP/IP Management Programming Manual

Commands and Responses
HP NonStop TCP/IP Management Programming Manual—529636-001
6-99
STATISTICS Command
ZSPI-TKN-RETCODE
specifies whether the command has been completed successfully. The value of
this token remains zero (ZCOM-ERR-OK) when the command is completed
successfully with or without a warning. Note that if the empty response is returned,
the value of this token is nonzero, although the command is completed
successfully.
If the command is not completed successfully, the value of this token indicates the
reason the command failed. Always check the contents of the error list to
determine the token or value in error. For details on the ZCOM return codes, see
the SPI Common Extensions Manual.
The possible nonzero values of RETCODE in response to the STATISTICS
command are:
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-CMD-NOT-SUPP (-5)
ZSPI-TKN-ERRLIST
indicates the beginning of an error list. For more details, see SPI Standard
Definitions on page 5-1.
ZSPI-TKN-ENDLIST
indicates the end of a data list or an error list. For more details, see SPI Standard
Definitions on page 5-1.
ZSPI-TKN-CONTEXT
specifies whether the response continues with more response messages. If this
token is present, the response continues. If this token is not present, this response
message is the last of the response. For more details, see SPI Standard
Definitions on page 5-1.