TCP/IP Management Programming Manual

Commands and Responses
HP NonStop TCP/IP Management Programming Manual—529636-001
6-106
STATUS Command
ZCOM-TKN-OBJTYPE
specifies the type of object for which information was requested. The possible
values are ZCOM-OBJ-PROC, ZCOM-OBJ-SUBNET, and ZCOM-OBJ-ROUTE.
This token is present in every response record. The value of the ZCOM-TKN-
OBJTYPE token is the same as the value of the ZSPI-TKN-OBJECT-TYPE token
in the header. For more details, see Data Communications Standard Definitions on
page 5-9.
ZSPI-TKN-RETCODE
specifies whether the command has been completed successfully. The value of
this token remains zero (ZCOM-ERR-OK) when the command is completed
successfully with or without a warning. Note that if the empty response (ZCOM-
ERR-EMPT-RSP) is returned, the value of this token is nonzero, although the
command is completed successfully.
If the command is not completed successfully, the value of this token indicates the
reason the command failed. Always check the contents of the error list to
determine the token or value in error. For details on the ZCOM return codes and
associated error lists, refer to the SPI Common Extensions Manual.
The possible nonzero values of RETCODE in response to the STATUS command
are:
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-CMD-NOT-SUPP (-5)
ZSPI-TKN-ERRLIST
indicates the beginning of an error list. For more details, see SPI Standard
Definitions on page 5-1.
ZSPI-TKN-ENDLIST
indicates the end of a data list or an error list. For more details, see SPI Standard
Definitions on page 5-1.