TCP/IP Management Programming Manual

Error Numbers and Error Lists

HP NonStop TCP/IP Management Programming Manual—529636-001

A-6

10: ZTCI-ERR-SNAP-MTU-NOT-AVAIL

The ADD SUBNET command has been issued for a SNAP subnet but could not be

executed because the SLSA LAN interface did not report the frame size that could be

sent over the line.

Tokens

ZSPI-TKN-ERROR

is the standard SPI error token described in the SPI Programming Manual. Its

value consists of the TCP/IP subsystem ID and the error number ZTCI-ERR-

SNAP-MTU-NOT-AVAIL. This token is always present in the error list.

ZCOM-TKN-OBJNAME

is the object name on which the error occurred in the command. This token is

present in the error list if its presence is relevant to the cause of the error; that is, if

the error was detected after the subsystem made choices based on the object

name, this token is present in the error list. Otherwise, this token is omitted from

the list.

ZCOM-TKN-OBJTYPE

is the object type provided with the command on which the error occurred. Its value

defines the type of object against which the command was issued. Its only possible

value is ZCOM-OBJ-SUBNET.

Recommended Action

The SLSA LAN interface is not reporting this value because the SLSA LIF is not

started. Start the SLSA LAN interface and then reissue the START SUBNET

command.

ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.

ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR.

ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING.

ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM.

ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.