TCP/IP Management Programming Manual

HP NonStop TCP/IP Management Programming Manual—529636-001
5-1
5 Common Definitions
The management-programming interfaces to the TCP/IP subsystem use definitions
from four sources: SPI standard definitions, EMS standard definitions, data
communications standard definitions, and TCP/IP subsystem-specific definitions. Many
of the definitions are used in multiple commands, responses, event messages, or error
lists.
This section contains general information that applies to all uses of the common
definitions in the interfaces to the TCP/IP subsystem. Information about a definition
that is specific to a particular command, response, event message, or error list is given
in the description for that item.
All definitions in this section are represented in DDL. Structures, both fixed and
extensible, are defined by using DDL DEF statements. For a brief explanation of DDL
as it applies to SPI, see the SPI Programming Manual.
Definitions are listed in alphabetic order within each category.
SPI Standard Definitions
Definitions whose names begin with ZSPI- are SPI standard definitions. These
definitions are available to all subsystems that support SPI procedures.
Table 5-1 lists only those SPI standard definitions that are used in the management-
programming interfaces to the TCP/IP subsystem. It does not list SPI error numbers or
definitions used only in error lists associated with those error numbers. For a
description of all SPI standard definitions, see the SPI Programming Manual.
The SPI definitions applicable to the TCP/IP subsystem consists of:
•
Header tokens
•
Simple tokens
•
Token and field values
•
Token types
•
Fixed structures
Table 5-1. SPI Standard Definitions (page 1 of 2)
Header Tokens Other Simple Tokens
ZSPI-TKN-CHECKSUM ZSPI-TKN-ALLOW-TYPE
ZSPI-TKN-COMMAND ZSPI-TKN-COMMENT
ZSPI-TKN-HDRTYPE ZSPI-TKN-CONTEXT
ZSPI-TKN-MAX-FIELD-VERSION ZSPI-TKN-DATALIST
ZSPI-TKN-MAXRESP ZSPI-TKN-ENDLIST
ZSPI-TKN-OBJECT-TYPE ZSPI-TKN-ERRLIST