TCP/IP Management Programming Manual

Commands and Responses
HP NonStop TCP/IP Management Programming Manual—529636-001
6-24
ALTER Command
If the command is not completed successfully, the value of this token indicates the
reason the command failed. Always check the contents of the error list to
determine the token or value in error. For details on the ZCOM return codes, see
the SPI Common Extensions Manual. For details on the ZTCI return codes, see
Appendix A, Error Numbers and Error Lists. The possible nonzero values of
RETCODE in response to the ALTER command are:
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-CMD-NOT-SUPP (-5)
ZCOM-ERR-CMD-INV-IN-SUMSTATE (-3)
ZTCI-ERR-ATTR-OUT-OF-RANGE (5)
ZTCI-ERR-DUP-ADDR (7)
ZSPI-TKN-ERRLIST
indicates the beginning of an error list. For more details, see SPI Standard
Definitions on page 5-1.
ZSPI-TKN-ENDLIST
indicates the end of a data list or an error list. For more details, see SPI Standard
Definitions on page 5-1.
Operational Notes
•
ALTER is a sensitive command.
•
The object must be in the STOPPED summary state when the ALTER command is
issued.
•
When the ALTER command is completed, the object remains in the same state as
before the command was executed.
•
To obtain attributes of a process or subnet, use the INFO command.