TCP/IP (Parallel Library) Configuration and Management Manual

SCF Reference for Parallel Library TCP/IP
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
5-9
Parallel Library TCP/IP SCF Commands
•
In the STARTING summary state, the object has been initialized and is attempting
to start.
Parallel Library TCP/IP SCF Commands
This subsection contains the following information:
•
A table describing the Subsystem Control Facility (SCF) commands supported by
the Parallel Library TCP/IP subsystem and the object types supported for each
command.
•
Detailed information on object specification syntax.
•
The following detailed information about each SCF command:
°
A description of the command function.
°
The command syntax.
°
The object specification, which shows the supported object types and object
names.
°
Descriptions, by object type, of the attributes.
°
Considerations you should be aware of before using the command.
°
Command examples.
Supported Commands and Object Types
This section describes the SCF commands that are interpreted specifically for the
Parallel Library TCP/IP subsystem. The SCF Reference Manual for G-Series RVUs
provides general information about SCF commands. You should be familiar with that
information before reading the Parallel Library TCP/IP subsystem-specific information
provided here.
Table 5-4
lists the SCF commands and object types supported by the TCPMAN
process. The page number of the command description follows the command name.
Table 5-4. Commands and Object Types for TCPMAN (page 1 of 2)
Object Types
SCF
Command ENTRY MON PROCESS ROUTE SUBNET
ABORT Command
, 5-12 XX X X
ADD Command
, 5-17 XXX
ALTER Command
, 5-25 XX
DELETE Command
, 5-33 XXX
INFO Command
, 5-36 XXX X X