TCP/IP (Parallel Library) Configuration and Management Manual

SCF Reference for Parallel Library TCP/IP
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
5-33
DELETE Command
•
No other option parameters are allowed in the ALTER SUBNET command when
the ASSOCIATESUB parameter is present.
•
For the two subnets configured as a failover pair, you cannot assign an alias
address before the ASSOCIATESUB is done.
•
For the two subnets configured as a failover pair, you cannot alter the subnet IP
address or subnetmask once they are configured.
•
In a failover-enabled SUBNET pair with SHAREDIP, one SUBNET is designated as
primary after completion of the ALTER SUBNET, ASSOCIATESUB command.
•
Alias IP addresses are added by using the ALTER SUBNET , ADDALIAS
command. This consideration documents the failover behavior of alias IP
addresses.
If the SUBNET is configured for failover, all IP aliases are also configured for
failover as long as the IP alias address is added to both SUBNETs in the failover
pair. This arrangement is true for both SHARED and NONSHARED failover
configurations. If the alias IP address is only added to one SUBNET in a failover
pair, the alias IP address does not switch to another SUBNET when its SUBNET
fails.
DELETE Command
The DELETE command removes entry names, subnets, and routes from the Parallel
Library TCP/IP subsystem. You cannot delete a process or a TCPMON. (To delete
TCPMONs from the subsystem, see the ABORT MON Command for TCPMAN on
page 5-12.)
This is a sensitive command.
DELETE ENTRY Command for TCPMAN
The DELETE ENTRY command removes entries from the ARP table. Entries can be
deleted by specifying the entry name or by specifying the IP address. Specifying the IP
address is the only way dynamically added entries can be deleted.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
DELETE [ /OUT file-spec/ ] [ ENTRY $ZZTCP.*.entry-name ]