TCP/IP (Parallel Library) Configuration and Management Manual

SCF Reference for Parallel Library TCP/IP

HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006

5-68

NAMES ROUTE Command for TCPSAM

The NAMES ROUTE command for TCPSAM displays the names of the routes

configured in the same processor as the TCPSAM process.

Command Syntax

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

ROUTE $tcpsam-name.*

is the name of the route. The wild card (*) is used in place of the route-name

because the purpose of the NAMES ROUTE command is to obtain a list of all

routes. If you omit the process name, SCF uses the process name established in a

previous ASSUME command. See the SCF Reference Manual for G-Series RVUs

for more information about the ASSUME command.

Examples

The following command requests a list of the routes running in the same processor as

TCPSAM:

SCF> NAMES ROUTE $ZTC1.*

NAMES ROUTE Display Format

The format of the display for the NAMES ROUTE command is:

NAMES [ / OUT file-spec / ]

[ROUTE $tcpsam-name.*]

TCPIP Names ROUTE \BOBAFET.$ZTC1.*

ROUTE

#RT7 #RT8 #RT10 #DA2_2 #DEF