TCP/IP (Parallel Library) Configuration and Management Manual

SCF Reference for Parallel Library TCP/IP
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
5-70
NAMES SUBNET Command for TCPSAM
NAMES SUBNET Command for TCPSAM
NAMES SUBNET for TCPSAM displays the names of the subnets configured on the
TCPMON process in the same processor.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
SUBNET $tcpsam-name.subnet-name
is the name of the subnet. The fully-qualified name of the subnet for TCPSAM is
$tcpsam-name.subnet-name. If you omit the process name, SCF uses the
assumed object name. For information about the ASSUME command, see the
SCF Reference Manual for G-Series RVUs. You may substitute the wild card (*) for
the subnet name which yields the subnet names on all configured subnets.
Examples
The following command requests the names of the subnets associated with $ZTC1:
SCF> NAMES SUBNET $ZTC1.*
NAMES SUBNET Display Format
The format of the display for the NAMES SUBNET command is:
PRIMARY Command
The PRIMARY command can be used when the Parallel Library TCP/IP subsystem is
running as a fault-tolerant process pair. This command causes the backup processor to
become the primary processor and the primary processor to become the backup
processor. This is a sensitive command.
PRIMARY PROCESS Command for TCPMAN
The PRIMARY command for TCPMAN causes the backup processor for the TCPMAN
process ($ZZTCP) to become the primary and the primary processor to become the
backup.
NAMES [ / OUT file-spec / ] [ SUBNET $tcpsam-name.* ]
TCPMAN Names SUBNET \BEAR.$ZTC1.*
SUBNET
#LOOP0 #EN1 #EN2