TCP/IP (Parallel Library) Configuration and Management Manual

SCF Reference for Parallel Library TCP/IP
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
5-117
STATS ROUTE Command for TCPSAM
Name
is the name of the route.
Route Usage
is the number of times this route was used to send IP datagrams.
STATS ROUTE Command for TCPSAM
The STATS ROUTE command displays the Parallel Library TCP/IP subsystem
statistics for the specified routes in the processor containing the TCPSAM process.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
ROUTE $tcpsam-name.route-name
is the name of the route. The fully-qualified name for the ROUTE is $tcpsam-
name.route-name. You may substitute the wild card (*) for the route name; doing
so retrieves STATS for all routes in the TCPSAM primary processor. If you omit the
object name, SCF uses the assumed object name. For information about the
ASSUME command, see the SCF Reference Manual for G-Series RVUs.
RESET
resets the statistical counters to zero. (This option is sensitive.)
Example
The following command requests statistics for the specified TCPSAM process.
->STATS ROUTE $ZSAM1.*
Note. STATS ROUTE with the RESET option is sensitive.
STATS [ / OUT file-spec / ] [ROUTE $tcpsam-name.route-name]
[, RESET ]