TCP/IP (Parallel Library) Configuration and Management Manual

SCF Reference for Parallel Library TCP/IP
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
5-130
STATUS PROCESS Command for TCPSAM
Status
always indicates that the process is STARTED.
PPID
is the processor and process ID of the TCPMAN primary process.
BPID
is the processor and process ID of the TCPMAN backup process. If TCPMAN is
running without a backup process, this field shows ( 0, 0).
STATUS PROCESS Command for TCPSAM
The STATUS PROCESS command displays the dynamic state of the TCPSAM
process and any in-use ports.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
PROCESS $tcpsam-name
is the name of the TCPSAM process. If you omit the object name, SCF uses the
assumed object name. For information about the ASSUME command, see the
SCF Reference Manual for G-Series RVUs.
Examples
The following command displays the dynamic state of TCPSAM process, $SAM2, and
any in-use ports:
-> STATUS PROCESS $SAM2 , detail
STATUS [ / OUT file spec / ] [ PROCESS $tcpsam-name ]
[, DETAIL]