TCP/IP (Parallel Library) Configuration and Management Manual

SCF Reference for Parallel Library TCP/IP
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
5-135
STATUS ROUTE Command for TCPSAM
STATUS ROUTE Command for TCPSAM
This command displays the status of the routes configured in the TCPMON on the
TCPSAM primary processor. This is a nonsensitive command.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
ROUTE $tcpsam-name.#route-name
is the specification of the route name. The fully-qualified route name for TCPSAM
is $tcpsam-name.#route-name. To obtain status information about all routes
configured on the TCPSAM primary processor, use the wild-card (*) notation for
the route name. For example, STATUS ROUTE $ZTC1.*. To obtain status
information about one route, qualify the route name. For example, STATUS
ROUTE $ZTC1.#RT1.
If you omit the object name, SCF uses the assumed object name. For information
about the ASSUME command, see the SCF Reference Manual for G-Series RVUs.
Examples
-> STATUS ROUTE $ZTC1.*
STATUS ROUTE Display Format
The format of the display for the STATUS ROUTE command is:
Name
is the name of the route.
Status
is the summary state of the route.
STATUS [ / OUT file spec / ]
[ROUTE $tcpsam-name.#route-name ]
TCPIP Status ROUTE \BOBAFET.$ZTC1.*
Name Status RefCnt
#RT2 STARTED 1D
#RT3 STARTED 0D
#DA2_2 STARTED 0D