TCP/IP (Parallel Library) Configuration and Management Manual

SCF Reference for Parallel Library TCP/IP
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
5-138
STATUS SUBNET Command for TCPSAM
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
SUBNET $tcpsam-name.#subnet-name
is the specification of the subnet. The fully-qualified subnet name for TCPSAM is
$tcpsam-name.#subnet-name. To obtain information about all running subnets
in the TCPSAM primary processor, substitute the wild card (*) for the subnet name.
If you omit the object name, SCF uses the assumed object name. For information
about the ASSUME command, see the SCF Reference Manual for G-Series RVUs.
Example
The following example shows the command and display for STATUS SUBNET. The
wild card (*) is used to obtain status information on all subnets.
-> STATUS SUBNET $ZTC1.*
STATUS SUBNET Display Format
The format of the display for the STATUS SUBNET command is:
Name
is the name of the subnet.
Status
is the summary state of the subnet.
Considerations
A pound sign (#) precedes the SUBNET name for backward compatibility with
applications that expect this naming convention for SUBNETs. See Supported
Commands and Object Types on page 5-9.
STATUS [ / OUT file spec / ]
[SUBNET $tcpsam-name.#subnet-name]
TCPIP Status SUBNET \BOBAFET.$ZTC1.*
Name Status
#LOOP0 STARTED
#SN1 STARTED
#SN2 STOPPED