TCP/IP (Parallel Library) Configuration and Management Manual

SCF Error Messages

HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006

B-6

PTCPIP 00036

Cause. The subnet intended to be used for failover is not configured.

Effect. The command is rejected with the reason.

Recovery. Configure the subnet associated with the error and re-issue the command.

PTCPIP 00037

Cause. The command issued to configure failover is not valid. Two subnets intended

to be linked as a failover pair should have the same failover-enabled type, either

SHAREDIP or NONSHAREDIP.

Effect. The command is rejected with the reason.

Recovery. Re-issue the command with the two subnets having the same

failover-enabled type, either SHAREDIP or NONSHAREDIP. If both subnets are

SHAREDIP FAILOVER type, the RESERVEDIP parameter is also required.

PTCPIP 00038

Cause. The failover brother needs to be in STOPPED state before either subnet in the

failover pair can be deleted.

Effect. The command is rejected with the reason.

Recovery. Abort the associated subnet/brother and re-issue the command.

PTCPIP 00039

Cause. The failover brother was already associated with another subnet.

Effect. The command is rejected with the reason.

Recovery. Re-issue the command using another subnet not linked in a failover pair.

PTCPIP 00036 The subnet intended to be used for FAILOVER is

not configured.

PTCPIP 00037 The command issued to configure FAILOVER is not

valid.

PTCPIP 00038 The FAILOVER brother needs to be in STOPPED

state.

PTCPIP 00039 The FAILOVER brother was already associated with

other subnet.