TCP/IP (Parallel Library) Configuration and Management Manual

Tracer Utility
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
C-3
Running the Tracer Utility from a Terminal
[ -v ]
specifies verbose output. If you specify this option, all received ICMP packets are
listed. If you do not specify this option, only the ICMP packets TIME_EXCEEDED
and UNREACHABLE are listed.
[ -w wait-time ]
specifies the time, in seconds, that the Tracer Utility waits for a response to a
probe. If you do not specify this option, the Tracer Utility uses the default value of 5
seconds for wait-time.
remote-host-name
specifies the name or IP address of the remote host system to which the Tracer
Utility is to trace the path. This parameter is required. You must specify it following
any Tracer options (-d, -m, -n, -p, -q, -r, -s, -v, or -w).
[ data-size ]
specifies the packet-size in bytes. If you do not specify data-size, the Tracer
Utility uses the default probe-datagram length. The default probe-datagram length
is 38 bytes. You must specify data-size immediately following the specification
of host-name.