TCP/IP (Parallel Library) Configuration and Management Manual

Configuration Quick Start
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
1-11
Tasks: Starting Parallel Library TCP/IP With DNS
b. Check that QIOMON is running. Enter the following command at the SCF
prompt:
You should see a $ZMnn process running in every processor in which you
plan to run Parallel Library TCP/IP. If you do not, refer to the QIO Configuration
and Management Manual.
c. Check that TCPMAN is not already running on the system. Enter the following
command at the SCF prompt:
$ZZTCP should not appear in the list of processes. If $ZZTCP does appear,
you cannot start Parallel Library TCP/IP because Parallel Library TCP/IP is
already running. If you want to make changes to the configuration, see
Section 5, SCF Reference for Parallel Library TCP/IP.
d. Check that the SLSA subsystem is configured. Enter the following command at
the SCF prompt:
You should see $ZZLAN in the STARTED state. If you do not, refer to the LAN
Configuration and Management Manual.
e. Select a LIF of TYPE ETHERNET.
a. Obtain a list of all LIFs. Enter the following command at the SCF prompt:
b. Using one of the LIF names from Step a
, determine if the LIF is of TYPE
ETHERNET by issuing the following command at the SCF prompt:
f. Ensure that the LIF you are configuring for Parallel Library TCP/IP is
accessible to all processors on which you plan to run Parallel Library TCP/IP
by entering the following command at the SCF prompt:
The CPUs with Data Path field lists the processors to which the LIF is
accessible.
g. Enter the name of this LIF on Line # 5
, SLSA LIF Name, of Configuration Form 2
on page 1-12.
->STATUS MON $ZM*
->LISTDEV PTCPIP
->STATUS PROCESS $ZZLAN
->STATUS LIF $ZZLAN.*
->INFO LIF $ZZLAN.LAN02
->STATUS LIF $ZZLAN.LAN02, DETAIL