TCP/IP (Parallel Library) Configuration and Management Manual

Configuration Quick Start
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
1-13
Tasks: Starting Parallel Library TCP/IP With DNS
4. Save the system configuration database by entering the following SCF command.
Substitute the numbering scheme you identified on Configuration Form 2, Line # 1,
for the variable (01.05):
5. Create a TACL command file called TCPIPUP as in Example 1-2 on page 1-14.
Place the file in your whichever volume you choose, but note the location on Line 9
of the Configuration Form 2 on page 1-12 for future reference. You can copy this
command file from this manual available in the NonStop Technical Library (NTL).
Replace the variables (in italics) with the values you recorded on Configuration
Form 2 on page 1-12. The primary and backup processors for processes are also
variable but were not included on Configuration Form 2 on page 1-12. Select these
processors according to your system needs or use the ones in the example.
6. Enter the following command at the TACL prompt:
7. Route Name Arbitrary; you assign. ROUTE2
8. Gateway/router
address
Must be an IP address associated with a
router on your network subnet (obtain from
your network administrator.)
150.20.30.2
9. Location of
TCPIPUP
Get the location of your TACL command file
from Step 5
on page 1-13. (Note: you can fill
this field in later when you get to Step 5.)
$GUEST.USER
10. TCPSAM Name Arbitrary; you assign. $ZSAM2
11. LISTNER Name Arbitrary; you assign. $LSN2
12. TELSERV Name Arbitrary; you assign. $ZTN2
->SAVE CONFIGURATI0N 01.05
Note. See the TCP/IP (Parallel Library) Migration Guide for important information about
saving your configuration database and preserving all your system configuration
parameters. Also, see Configuration Database Management
on page 4-2.
>TEDIT TCPIPUP
Table 1-4. Configuration Form 2 for HOSTS File Startup (page 2 of 2)
Line
#
Variable Name/
Note Source
Step or
Example 1-2
Uses...