TCP/IP (Parallel Library) Configuration and Management Manual

Configuration Quick Start
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
1-15
Starting TCPMAN Using the RUN Command
7. Get the location of your TACL command file from Line 9 of Configuration Form 2
on page 1-12 and substitute this value for the variable location GUEST.USER in the
following example command. Issue the following TACL OBEY command on the
TCPIPUP command file while running as user SUPER.SUPER:
8. Test that the Parallel Library TCP/IP subsystem is running on the desired IP
address. You can use the INFO SUBNET Command for TCPMAN to get the IP
address for use in the following command sequence.
Enter the following commands at the TACL prompt:
Starting TCPMAN Using the RUN Command
Use this procedure if you have stopped Parallel Library TCP/IP without clearing the
system configuration database (see Stopping Parallel Library TCP/IP and Preserving
the Current Configuration on page 1-19). This procedure assumes that you have
started Parallel Library TCP/IP at least once before. SCF objects have been configured
before and not deleted when Parallel Library TCP/IP was stopped, are available upon
restart with this procedure.
This procedure uses some variables, such as primary and backup processors and the
name of the TCPSAM process. These variables are indicated in italics. For information
on how to obtain real values for all variables except the backup and primary
processors, see Configuration Form 1 on page 1-5. Select backup and primary
processors according to your system needs.
Task Summary
Task 1: Check the TCP/IP (Parallel Library) Migration Guide for any considerations that
affect your configuration.
Task 2: Check that all assumptions are met.
Task 3: Clear all DEFINEs and PARAMs.
Task 4: Set up the environment to use a HOSTS file or DNS
>OBEY $GUEST.USER.TCPIPUP
Note. If you receive an error saying that one or more of the LISTNER or TELSERV process
file names is already in use, use the procedures for Stopping Parallel Library TCP/IP and
Clearing the Database on page 1-24 to clear out Parallel Library TCP/IP environment and use
the TACL STOP command to stop the LISTNER and TELSERV processes that caused the
error. (It’s possible for socket applications to be bound to the SRL without having an open
socket. Hence, their file names would be in use but they would not show up in the LISTOPENS
MON command.)
>TELNET ip-address
>TACL
>LOGON SUPER.SUPER