TCP/IP (Parallel Library) Configuration and Management Manual

Configuration Quick Start
HP NonStop TCP/IP (Parallel Library) Configuration and Management Manual—522271-006
1-16
Tasks: Starting Parallel Library TCP/IP Using RUN
Command
Task 5: Issue the TACL RUN command to start Parallel Library TCP/IP.
Task 6: Start TCPSAM for socket programs.
Task 7: Test the Parallel Library TCP/IP environment.
Tasks: Starting Parallel Library TCP/IP Using RUN Command
1. Check for considerations that affect your configuration. See the TCP/IP (Parallel
Library) Migration Guide.
2. Check that the following assumptions are met.
a. Check that the SCF environment is operational (that is, $ZNET is STARTED).
Enter the following command at the TACL prompt:
$ZNET should be running. If $ZNET is not running, see the SCF Reference
Manual for G-Series RVUs.
b. Check that QIOMON is running. Enter the following command at the SCF
prompt:
You should see a $ZMnn process running in every processor in which you
plan to run Parallel Library TCP/IP. If you do not, refer to the QIO Configuration
and Management Manual.
c. Check that TCPMAN is not already running on the system. Enter the following
command at the SCF prompt:
$ZZTCP should not appear in the list of processes. If it does appear, you
cannot start Parallel Library TCP/IP because Parallel Library TCP/IP is already
running. If you want to make changes to the configuration, see Section 5, SCF
Reference for Parallel Library TCP/IP.
d. Check that the SLSA subsystem is configured. Enter the following command at
the SCF prompt:
You should see $ZZLAN in the STARTED state. If you do not, refer to the LAN
Configuration and Management Manual.
>STATUS $ZNET
->STATUS MON $ZM*
->LISTDEV PTCPIP
->STATUS PROCESS $ZZLAN