TCP/IP TELNET Management Programming Manual

STATUS Command
Commands and Responses
53474 Tandem Computers Incorporated 6–65
ZCOM-TKN-OBJTYPE
specifies the type of object for which information was requested. The possible
values are ZCOM-OBJ-PROC and ZCOM-OBJ-WINDOW. This token is present in
every response record. The value of the ZCOM-TKN-OBJTYPE token is the same
as the value of the ZSPI-TKN-OBJECT-TYPE token in the header. See Section 5,
“Common Definitions,” for a detailed description of this token.
ZSPI-TKN-RETCODE
specifies whether the command completed successfully. If the command
completed successfully, including when the command completes with a warning,
the value of this token is zero (ZCOM-ERR-OK). Note that if the empty response
(ZCOM-ERR-EMPT-RSP) is returned, the value of this token is nonzero even
though the command has completed successfully.
If the command did not complete successfully, the value of this token indicates the
reason the command failed. Always check the contents of the error list to
determine the token or value in error. For details on the ZCOM return codes and
associated error lists, see the Communications Management Programming Manual.
For details on the ZSPI return codes and associated error lists, see the Distributed
Systems Management (DSM) Programming Manual.
The following nonzero values of RETCODE can be returned in response to the
STATUS command:
ZSPI-ERR-INVBUF (-1)
ZCOM-ERR-CMD-MISMATCH (-4)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-REQ (-29)
ZSPI-TKN-ERRLIST
indicates the beginning of an error list. In the error list, the object that experienced
the error is listed. See “SPI Standard Definitions” in Section 5 for a detailed
description of this token.
ZSPI-TKN-ENDLIST
indicates the end of a data list or an error list. See “SPI Standard Definitions” in
Section 5 for a detailed description of this token.