TCP/IP TELNET Management Programming Manual

ADD Command
Commands and Responses
6–8 53474 Tandem Computers Incorporated
Here are the possible nonzero values of RETCODE in response to the ABORT
command:
ZSPI-ERR-INVBUF (-1)
ZCOM-ERR-CMD-MISMATCH (-4)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-OBJ-ALRDY-IN-SUMSTATE (-16)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-REQ (-29)
ZSPI-TKN-ERRLIST
indicates the beginning of an error list. In the error list, the object that experienced
the error is listed. See “SPI Standard Definitions” in Section 5 for a detailed
description of this token.
ZSPI-TKN-ENDLIST
indicates the end of a data list or an error list. See “SPI Standard Definitions” in
Section 5 for a detailed description of this token.
ZSPI-TKN-CONTEXT
specifies whether more response messages are going to be received for a response.
If this token is present, the response continues to the next response message. If
this token is not present, the response message is the last one received. See “SPI
Standard Definitions” in Section 5 for a detailed description of this token.
Operational Notes
ABORT is a sensitive command.
When the command is completed, the window is placed in the STOPPED
summary state.
Use the STOP command for more controlled termination of a window.
Use the START command to initiate the operation of a window.
Use the STATUS command to determine the state of a window.