TCP/IP TELNET Management Programming Manual

LISTOPENS Command
Commands and Responses
6–38 53474 Tandem Computers Incorporated
If the command did not complete successfully, the value of this token indicates the
reason the command failed. Always check the contents of the error list to
determine the token or value in error. For details on the ZCOM return codes, see
the Communications Management Programming Manual. For details on the ZSPI
return codes and associated error lists, see the Distributed Systems Management
(DSM) Programming Manual.
The following nonzero values of RETCODE can be returned in response to the
LISTOBJECTS command:
ZSPI-ERR-INVBUF (-1)
ZCOM-ERR-CMD-MISMATCH (-4)
ZCOM-ERR-CMD-TOO-LARGE (-8)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-SPI-ERR (-23)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-REQ (-29)
ZSPI-TKN-ERRLIST
indicates the beginning of an error list. See “SPI Standard Definitions” in Section 5
for a detailed description of this token.
ZSPI-TKN-ENDLIST
indicates the end of a data list or an error list. See “SPI Standard Definitions” in
Section 5 for a detailed description of this token.
ZSPI-TKN-CONTEXT
specifies whether more response messages are going to be received for a response.
If this token is present, the response continues to the next response message. If
this token is not present, the response message is the last to be received. See “SPI
Standard Definitions” in Section 5 for a detailed description of this token.
Operational Notes
LISTOBJECTS is a nonsensitive command.
When the command is completed, the objects remain in the same summary state as
they were before the command was executed.
The OBJNAME token is not required for any of the valid objects.