TCP/IPv6 Configuration and Management Manual (G06.24+)

HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
5-1
5
Example Illustrations and Adding
Features to the Basic Configuration
This section explains the configuration examples in Section 1, Quick Start and shows
you how to add more features to those basic examples.
This section also shows you how to configure the subsystem in INET and INETD
modes and discusses the benefits of NonStop TCP/IPv6 for WAN configurations.
Topics covered in this section include:
•
Illustrations of the Quick Start Examples
•
Adding More Features on page 5-7
•
Configure the Basic Subsystem for INET6 Mode on page 5-8
•
Plan Complex WAN Environments on page 5-9
Illustrations of the Quick Start Examples
This subsection provides figures to illustrate some of the examples provided in
Section 1, Quick Start. Illustrations for the following Quick Start examples are provided:
•
Logical Network Partitioning
•
DUAL Mode on page 5-2
•
DUAL Mode, Ethernet Failover on page 5-3
•
DUAL Mode, Ethernet Failover, Nonshared IP on page 5-5
•
DUAL-Mode, Configured Tunnel on page 5-6
Logical Network Partitioning
Example 1-4 on page 1-10 shows how to configure the subsystem with logical-network
partitioning. This configuration is shown in Figure 5-1.