TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
8-10
Supported Commands and Object Types
Supported Commands and Object Types
This section describes the SCF commands that are interpreted specifically for the
NonStop TCP/IPv6 subsystem. The SCF Reference Manual for G-Series RVUs and
SCF Reference Manual for H-Series RVUs provide general information about SCF
commands. You should be familiar with that information before reading the NonStop
TCP/IPv6 subsystem-specific information provided here.
Table 8-4 lists the SCF commands and object types supported by the TCP6MAN
process. The page number of the command description follows the command name.
Table 8-5 lists the SCF commands and object types supported by the TCP6SAM
process. The page number of the command description follows the command name.
Table 8-4. Commands and Object Types for TCP6MAN
Object Types
SCF
Command ENTRY MON PROCESS ROUTE SUBNET
ABORT Command
, 8-14 XX X X
ADD Command
, 8-19 XXX
ALTER Command
, 8-42 XX
DELETE Command
, 8-59 XXX
INFO Command
, 8-62 XXX XX
LISTOPENS Command
, 8-98 X
NAMES Command
, 8-104 XXX
PRIMARY Command
, 8-109 X
START Command
, 8-110 XXX
STATS Command
, 8-113 XXX
STATUS Command
, 8-168 XXX XX
STOP Command
, 8-192 XX X X
TRACE Command
, 8-196 XX X
VERSION Command
, 8-205 XX
Table 8-5. Commands and Object Types for TCP6SAM (page 1 of 2)
Object Types
SCF
Command PROCESS ROUTE SUBNET
ABORT Command
, 8-14 X
INFO Command
, 8-62 XX X
LISTOPENS Command
, 8-98 X