TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6

HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008

8-19

ADD Command

The ADD command adds a SUBNET, ROUTE or ENTRY to the NonStop TCP/IPv6

subsystem. You must enter an ADD SUBNET command for each SUBNET with which

the NonStop TCP/IPv6 subsystem is to communicate. Each SUBNET defines a point

of attachment through which data is sent or received. This is a sensitive command.

ADD ENTRY Command for TCP6MAN

The ADD ENTRY command creates an entry in an ARP table. Entries in the ARP table

provide a mapping between an IP address and a MAC address. The ENTRY object

name must start with the letters “EA.”

The ADD Entry command generates a link-level route. This link-level route has the

name specified in the entry-name variable of the ADD ENTRY command.

This command is valid only when you use IPv4 addresses.

Command Syntax

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

ENTRY $ZZTCP.*.entry-name

specifies the name of the ENTRY object. The fully-qualified entry name is

$ZZTCP.*.entry-name (you must add entries on all configured TCP6MONs.) If

you specify a portion of the fully-qualified name in a prior ASSUME command, you

can omit that portion of the name in this command. For information about the

ASSUME command, see the SCF Reference Manual for G-Series RVUs or the

SCF Reference Manual for H-Series RVUs. The naming convention for entries is

seven characters. The first two characters must be EA.

TYPE ARP

specifies the ENTRY type. The only supported type is ARP. A TYPE of ARP maps

an IP address with an Ethernet MAC address. The ARP type requires an IP

address and the MACADDR attribute.

ADD [ /OUT file-spec/ ] [ ENTRY $ZZTCP.*.entry-name ]

, TYPE ARP

, IPADDRESS ip-addr

, MACADDR mac-address

[ , ALLENTRY ON | OFF ]

[ , SUBNET subnet-name ]