TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
8-27
ADD SUBNET Command for TCP6MAN
INET (IPv4) Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
SUBNET $ZZTCP.*.subnet-name
is the name of the SUBNET. If you omit this attribute, SCF uses the assumed
SUBNET name. For information about the ASSUME command, see the SCF
Reference Manual for G-Series RVUs or the SCF Reference Manual for H-Series
RVUs. The fully-qualified SUBNET name is $ZZTCP.*.subnet-name. You must
add SUBNETs to all configured TCP6MONs; if you do not specify the wild card (*)
for the monitors, it is assumed. The naming convention for SUBNETs is seven
characters. The first character must be a letter. HP recommends making the first
two characters SN.
TYPE ETHERNET
specifies the type of SUBNET to be added. The only valid type is Ethernet. This
parameter is required. There is no default.
DEVICENAME lif-name
is the name of the device to be opened to connect to the network. This
corresponds to the ServerNet LAN systems access (SLSA) logical interface (LIF).
The LIF provides access to the Ethernet LAN. For information on how to choose a
SLSA device name, see step 3 on page 1-3. When adding a SUBNET, the
DEVICENAME for the SLSA SUBNET does not begin with a dollar sign ($)
character. There is no default.
IPADDRESS ip-addr
is the 32-bit IPv4 address associated with this SUBNET interface. This parameter
is required. There is no default.
ADD [ /OUT file-spec/ ] [ SUBNET $ZZTCP.*.subnet-name ]
, TYPE ETHERNET
, DEVICENAME lif-name
, IPADDRESS ip-addr
[ , FAMILY INET ]
[ , IRDP { ON | OFF } ]
[ , SUBNETMASK mask-val ]
[ , FAILOVER {SHAREDIP | NONSHAREDIP} ]
[ , MTU size ]
[ , LNPTPLIST "tcp6sam list" ]