TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
8-104
NAMES Command
Fport
is the foreign port number for either TCP or UDP depending on the protocol listed
in the PROTO field. FPORT is displayed in text form for the more common port
values. It is displayed in decimal if they are not recognized as a common port.
NAMES Command
The NAMES command displays the names of the specified NonStop TCP/IPv6 objects.
This is a nonsensitive command.
NAMES ENTRY Command for TCP6MAN
The NAMES ENTRY command displays the names of the ENTRY objects for the
NonStop TCP/IPv6 subsystem in a configured TCP6MON or in all configured
TCP6MONs.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
ENTRY $ZZTCP.#ZPTMn.*
is the name of the entry. The wild card (*) is used in place of the entry-name
because the purpose of the NAMES ENTRY command is to obtain a list of all
entries. If you omit the process name, SCF uses the process name established in
a previous ASSUME command. For more information about the ASSUME
command, see the SCF Reference Manual for G-Series RVUs or the SCF
Reference Manual for H-Series RVUs. You may assume the process and
TCP6MON and you can use the wild card (*) for the TCP6MON and entry. The wild
card used in place of the TCP6MON yields a list of entries on all configured
TCP6MONs.
Examples
To provide a list of entries for all entries on the #ZPTM2 TCP6MON:
-> NAMES ENTRY $ZZTCP.#ZPTM2.*
NAMES [ /OUT file-spec/ ]
[ ENTRY $ZZTCP.#ZPTMn.* ]