TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
8-113
STATS Command
SUBNET $ZZTCP.#ZPTMn.subnet-name
is the name of the SUBNET. The fully-qualified SUBNET name is
$ZZTCP.*.subnet-name (you must alter the SUBNET on all configured
TCP6MONs). If you do not substitute the wild card (*) for the TCP6MON name, it is
assumed. If you omit the process or SUBNET name, SCF uses the assumed
object name. For information about the ASSUME command, see the SCF
Reference Manual for G-Series RVUs or the SCF Reference Manual for H-Series
RVUs.
Examples
This command starts SUBNET SN1 under all TCP6MONs:
-> START SUBNET $ZZTCP.*.SN1
This command is valid; the subsystem treats the command the same as the above
command with the wild card (*) for the monitor:
-> START SUBNET $ZZTCP.SN1
Considerations
•
The object-name template (wild-card notation) is supported.
•
When you use the START command, the object must be in the STOPPED
summary state.
•
The SLSA subsystem must be operational before SUBNETs can be started
successfully.
•
To terminate the operation of SUBNETs, use the STOP or ABORT command.
•
For the two SUBNETs configured as a failover pair, you cannot start either of the
SUBNETs before the ASSOCIATESUB command is done.
•
When the START command succeeds, the IPv4 and IPv6 filters are registered and
the SUBNET is placed in the STARTED state. If the SUBNET being configured is
for IPv4-only, only the IPv4 filters are registered. If the SUBNET being configured
is for IPv6-only, only the IPv6 filters are registered.
STATS Command
The STATS command returns statistics for a specified NonStop TCP/IPv6 object. The
STATS MON command returns statistics for the TCP6MONs running in every
processor while the STATS PROCESS command for TCP6SAM returns statistics only
for the processor in which the TCP6SAM process resides. All statistics are 32-bit
numbers. The letter D in the display values indicates that the value is a doubleword.
Note. You must start SUBNETs on all configured monitors.