TCP/IPv6 Configuration and Management Manual (G06.24+)

Quick Start
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
1-2
I. Prepare to Install and Configure NonStop
TCP/IPv6
The default mode for the NonStop TCP/IPv6 subsystem is INET (see NonStop
TCP/IPv6 Operating Modes on page 2-20).
I. Prepare to Install and Configure NonStop
TCP/IPv6
Before you install and configure NonStop TCP/IPv6, follow the procedures in this
subsection.
1. Check Assumptions Before Starting NonStop TCP/IPv6
Before starting the NonStop TCP/IPv6 subsystem, check that these assumptions are
met:
•
The SCF environment is operational (that is, $ZNET is STARTED).
•
QIOMON is running (that is, $ZMnn is STARTED).
•
SLSA is running (that is, $ZZLAN is STARTED).
•
Parallel Library TCP/IP and NonStop TCP/IPv6 are not already running on the
system. If NonStop TCP/IPv6 is already running and you want to reconfigure it in a
different mode, first stop the subsystem by following the procedures in Stopping
NonStop TCP/IPv6 on page 6-7, and then restart it by following the procedures in
this section (for INET or DUAL mode) or the procedures in Configure the Basic
Subsystem for INET6 Mode on page 5-8. On a NonStop S-series server, if Parallel
Library TCP/IP is running, you must stop it by using the procedure Stopping
NonStop TCP/IPv6 as a Generic Process on page 6-12, substituting TCPMON and
TCPSAM for TCP6MON and TCP6SAM in that procedure. You can also see the
TCP/IP (Parallel Library) Configuration and Management Manual, which has a
procedure for stopping Parallel Library TCP/IP as a generic process.
•
You are running as user SUPER.SUPER.
2. Prepare to Install and Configure the Subsystem
Before performing any of the configurations in these quick start examples, perform the
tasks in this subsection. These steps ensure that your environment is ready to run
NonStop TCP/IPv6. Variables in the examples are indicated with italics. You must
substitute real values from your environment for these variables.
Note. You cannot simultaneously run both the Parallel Library TCP/IP and NonStop TCP/IPv6
subsystems on the same system. Furthermore, Parallel Library TCP/IP is not supported on
Integrity NonStop servers.
Note. Issue the SCF LISTDEV TCPIPV6 and LISTDEV PTCPIP commands to determine
if either subsystem is running. (Parallel Library TCP/IP is not supported on Integrity
NonStop servers.)