TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6

HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008

8-162

STATS ROUTE Command for TCP6SAM

The STATS ROUTE command displays the NonStop TCP/IPv6 subsystem statistics for

the specified routes in the processor containing the TCP6SAM process.

Command Syntax

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

ROUTE $TCP6SAM-name.route-name

is the name of the route. The fully-qualified name for the ROUTE is $TCP6SAM-

name.route-name. You can substitute the wild card (*) for the route name; doing

so retrieves STATS for all routes in the TCP6SAM primary processor. If you omit

the object name, SCF uses the assumed object name. For information about the

ASSUME command, see the SCF Reference Manual for G-Series RVUs or the

SCF Reference Manual for H-Series RVUs.

RESET

resets the statistical counters to zero. (This option is sensitive.)

Example

To request statistics for the specified TCP6SAM process:

->STATS ROUTE $ZSAM1.*

STATS ROUTE for TCP6SAM Display Format

The format of the display for the STATS ROUTE command shown in the Example is:

Sample Time

is the time when the statistics were sampled (displayed or written to a file).

Note. STATS ROUTE with the RESET option is sensitive.

STATS [ / OUT file-spec / ] [ROUTE $TCP6SAM-name.route-name]

[, RESET ]

TCPIP Stats ROUTE \SYSA.$ZSAM1.*

Sample Time ... 23 March 1996, 17:18:25.334

Reset Time .... 23 March 1996, 11:47:47.166

Name Route Usage

#ROU1 10709D