TCP/IPv6 Configuration and Management Manual (G06.24+)

Quick Start
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
1-5
IIB. Install NonStop TCP/IPv6 (#ZZTCP is in the
Configuration Database)
You should see a display like this:
4. Start the NonStop TCP/IPv6 subsystem by entering this SCF command:
5. Proceed to Step IIIA. Configure the NonStop TCP/IPv6 Subsystem for INET Mode
on page 1-6 or Step IIIB. Configure the NonStop TCP/IPv6 Subsystem for DUAL
Mode on page 1-15.
IIB. Install NonStop TCP/IPv6 (#ZZTCP is in the
Configuration Database)
If you already have #ZZTCP in the system configuration database, follow this
procedure for replacing Parallel Library TCP/IP with NonStop TCP/IPv6. (This applies
to NonStop S-series servers only, since Parallel Library TCP/IP is not supported on
Integrity NonStop servers.)
1. Alter the #ZZTCP process to use the NonStop TCP/IPv6 program by entering
these SCF commands:
*AutoRestart...............0
*BackupCPU.................1
*CPU.......................Not Specified
*DefaultVolume.............$SYSTEM.SYSTEM
*ExtSwap...................Not Specified
*Highpin...................ON
*HomeTerminal..............$ZHOME
*InFile....................Not Specified
*Library...................Not Specified
*MemPages..................Not Specified
*Name......................$ZZTCP
*OutFile...................$ZHOME
*PFSSize...................Not Specified
*PrimaryCPU................0
*Priority..................180
*Program...................$SYSTEM.SYSTEM.TCP6MAN
*SaveAbend.................OFF
*StartMode.................SYSTEM
*StartupMessage............<BCKP-CPU>
*StopMode..................SYSMSG
*Type......................OTHER
*UserId....................SUPER.SUPER ( 255,255 )
->START PROCESS $ZZKRN.#ZZTCP
->ASSUME PROCESS $ZZKRN.#ZZTCP
->TIMEOUT
->ABORT
->ALTER, PROGRAM $SYSTEM.SYSTEM.TCP6MAN