TCP/IPv6 Configuration and Management Manual (G06.24+)

Quick Start
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
1-6
IIIA. Configure the NonStop TCP/IPv6 Subsystem for
INET Mode
2. Check that $ZZTCP has been added to the system configuration database by
entering this SCF command:
You should see a display like this:
3. Start the NonStop TCP/IPv6 subsystem by entering the SCF command:
4. Proceed to Step IIIA. Configure the NonStop TCP/IPv6 Subsystem for INET Mode
or Step IIIB. Configure the NonStop TCP/IPv6 Subsystem for DUAL Mode
on
page 1-15.
IIIA. Configure the NonStop TCP/IPv6
Subsystem for INET Mode
These procedures show you how to configure the NonStop TCP/IPv6 subsystem in
INET mode and include examples for failover configurations. In INET mode, NonStop
TCP/IPv6 supports only IPv4 communications.
Configure the Subsystem for INET-Mode
1. Find a LIF for communication by following the procedure Select a LIF of TYPE
ETHERNET for communications. on page 1-3.
->INFO PROCESS $ZZKRN.#ZZTCP, DETAIL
*AutoRestart...............0
*BackupCPU.................1
*CPU.......................Not Specified
*DefaultVolume.............$SYSTEM.SYSTEM
*ExtSwap...................Not Specified
*Highpin...................ON
*HomeTerminal..............$ZHOME
*InFile....................Not Specified
*Library...................Not Specified
*MemPages..................Not Specified
*Name......................$ZZTCP
*OutFile...................$ZHOME
*PFSSize...................Not Specified
*PrimaryCPU................0
*Priority..................180
*Program...................$SYSTEM.SYSTEM.TCP6MAN
*SaveAbend.................OFF
*StartMode.................SYSTEM
*StartupMessage............<BCKP-CPU>
*StopMode..................SYSMSG
*Type......................OTHER
*UserId....................SUPER.SUPER ( 255,255 )
->START PROCESS $ZZKRN.#ZZTCP