TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
8-183
STATUS ROUTE Command
STATUS ROUTE Command
This command displays the status of the routes configured in the TCP6MON on the
TCP6SAM primary processor. This is a nonsensitive command.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
ROUTE $TCP6SAM-name.#route-name
is the specification of the route name. The fully-qualified route name for TCP6SAM
is $TCP6SAM-name.#route-name. To obtain status information about all routes
configured on the TCP6SAM primary processor, use the wild-card (*) notation for
the route name. For example, STATUS ROUTE $ZTC1.*. To obtain status
information about one route, qualify the route name. For example, STATUS
ROUTE $ZTC1.#RT1.
If you omit the object name, SCF uses the assumed object name. For information
about the ASSUME command, see the SCF Reference Manual for G-Series RVUs
or the SCF Reference Manual for H-Series RVUs.
Examples
To obtain status information about all routes:
-> STATUS ROUTE $ZTC1.*
INET Either a Host or Network route of the INET family
INET6 Either a Host or Network route of the INET6 family
ARP A route related to an ARP cache
ND6 A route related to an ND6 neighbor discovery cache
STATUS [ / OUT file spec / ]
[ROUTE $TCP6SAM-name.#route-name ]