TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
8-185
STATUS SUBNET Command for TCP6MAN
If you omit the object name, SCF uses the assumed object name. For information
about the ASSUME command, see the SCF Reference Manual for G-Series RVUs
or the SCF Reference Manual for H-Series RVUs.
Examples
This example shows the command and display for STATUS SUBNET. The wild card (*)
is used to obtain status information about all SUBNETs configured for the TCP6MON
process of processor 3.
-> STATUS SUBNET $ZZTCP.#ZPTM3.*
This example shows the command and display for STATUS SUBNET, DETAIL. The
wild card (*) is used to obtain detailed status information about all SUBNETs configured
for the TCP6MON process of processor 3.
-> STATUS SUBNET $ZZTCP.#ZPTM3.*, DETAIL
STATUS SUBNET Display Format
The format of the display for the STATUS SUBNET command is:
Name
is the name of the SUBNET.
Status
is the summary state of the SUBNET.
FailOver
indicates whether the SUBNET is failover enabled or not. When the SUBNET is
failover enabled, possible values are:
SharedIP
indicates whether the SUBNET has the same SUBNET IP address as its brother.
TCPIPV6 Status SUBNET \MYSYS.$ZZTCP.#ZPTM3.*
Name Status FailOver SharedIP Alias A-Subnet M-State IPv6 Pv4
SN2 STARTED V4-V6 NO NO SN1 UP YES YES
SN1 STARTED V4-V6 NO NO SN2 UP YES YES
LOOP0 STARTED NO NO NO NA YES YES
TUN STARTED NO NO NO NA YES NA
V4 The SUBNET is only IPv4 failover enabled
V6 The SUBNET is only IPv46 failover enabled
V4-V6 The SUBNET is Failover enabled for both IPv4 and
IPv6.