TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
8-191
STATUS SUBNET Command for TCP6SAM
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
SUBNET $TCP6SAM-name.#subnet-name
is the specification of the SUBNET. The fully qualified SUBNET name for
TCP6SAM is $TCP6SAM-name.#subnet-name.To obtain information about all
running SUBNETs in the TCP6SAM primary processor, substitute the wild card (*)
for the SUBNET name.
If you omit the object name, SCF uses the assumed object name. For information
about the ASSUME command, see the SCF Reference Manual for G-Series RVUs
or the SCF Reference Manual for H-Series RVUs.
Example
This example shows the command and display for STATUS SUBNET. The wild card (*)
is used to obtain status information on all SUBNETs.
-> STATUS SUBNET $ZTC1.*
STATUS SUBNET for TCP6SAM Display Format
The format of the display for the STATUS SUBNET command is:
Name
is the name of the SUBNET.
Status
is the summary state of the SUBNET.
STATUS [ / OUT file spec / ]
[SUBNET $TCP6SAM-name.#subnet-name]
TCPIP Status SUBNET \MYSYS.$ZTC1.*
Name Status
#LOOP0 STARTED
#SN1 STARTED
#SN2 STOPPED