TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
8-204
TRACE SUBNET Command for TCP6MAN
SUBNET $ZZTCP.#ZPTMn.subnet-name
is the name of the SUBNET. If you omit the object name, SCF uses the assumed
object name. For information about the ASSUME command, see the SCF
Reference Manual for G-Series RVUs or the SCF Reference Manual for H-Series
RVUs.
STOP
ends the trace operation. A TRACE command must include either the STOP option
or the TO option.
TO file-spec
specifies the name of the file into which the results of the trace operation are to be
placed. It is a required option if the STOP option is not used.
NOBULKIO
specifies that TRACE should not use bulk I/O for tracing. (BULKIO, not supported
in NonStop TCP/IPv6, specifies that the TRACE collector use Bulk I/O to write data
to the disk file, thus reducing the number of missing frame errors reported by
PTRACE.) NOBULKIO is a required parameter.
SELECT
selects the operations to be traced.
For the SUBNET object, you can specify these for select-spec:
COUNT count
specifies the number of trace records to be captured. count is an integer in the
range -1 through 32767. If this option is omitted or if count equals -1, records are
accumulated until you use the STOP option.
NOCOLL
indicates that the trace collector process should not be initiated. WRAP and
NOCOLL cannot be specified at the same time.
ALL All records
IPI IP Input records
IPO IP Output records
ARPI ARP Input records
ARPO ARP Output records
LOGIC A combination of all the above records
USERDATA Used with IPI and IPO to display user data