TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Error Messages
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
C-6
TCPIPV6 00036
Cause. The SUBNET intended to be used for failover is not configured.
Effect. The command is rejected with the reason.
Recovery. Configure the SUBNET associated with the error and reissue the
command.
TCPIPV6 00037
Cause. The command issued to configure failover is not valid. Two SUBNETs
intended to be linked as a failover pair should have the same failover-enabled type,
either SHAREDIP or NONSHAREDIP.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with the two SUBNETs having the same
failover-enabled type, either SHAREDIP or NONSHAREDIP. If both SUBNETs are
SHAREDIP FAILOVER type, the RESERVEDIP parameter is also required.
TCPIPV6 00038
Cause. The failover brother needs to be in STOPPED state before either SUBNET in
the failover pair can be deleted.
Effect. The command is rejected with the reason.
Recovery. Abort the associated SUBNET/brother and reissue the command.
TCPIPV6 00039
Cause. The failover brother was already associated with another SUBNET.
Effect. The command is rejected with the reason.
Recovery. Reissue the command using another SUBNET not linked in a failover pair.
TCPIPV6 E00036 The subnet intended to be used for FAILOVER is
not configured.
TCPIPV6 E00037 The command issued to configure FAILOVER is
not valid.
TCPIPV6 E00038 The FAILOVER brother needs to be in STOPPED
state.
TCPIPV6 E00039 The FAILOVER brother was already associated
with other subnet.