TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Error Messages
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
C-7
TCPIPV6 00040
Cause. The command is invalid in the failover-enabled SUBNET. Causes include:
•
For a failover-enabled SUBNET, the ADDALIAS is not allowed until the SUBNET is
associated with another SUBNET as a failover pair.
•
For a failover-enabled SUBNET, the DELETEALIAS is not allowed.
•
For a failover-enabled SUBNET, the ALTER SUBNET, IPADDDRESS or ALTER
SUBNET, SUBNETMASK command is not allowed.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with correct parameters.
TCPIPV6 00041
Cause. This command is not valid for IPv6 configuration. Either a required parameter
is missing or mismatched parameters were detected in the command.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with correct parameters.
TCPIPV6 00042
Cause. The SUBNET is not enabled for IPv6.
Effect. The command is rejected with the reason.
Recovery. : Reissue the command with the SUBNET in the correct state.
TCPIPV6 00043
Cause. The IPv6 address specified in the command is not valid.
Effect. The command is rejected with the reason.
TCPIPV6 E00040 The command is not valid for FAILOVER enabled
subnet.
TCPIPV6 E00041 The command is not valid for configuring
AF_INET6 subnet.
TCPIPV6 E00042 The subnet state is invalid for configuring
AF_INET6.
TCPIPV6 E00043 The IPv6 address specified in the command is
not valid.