TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Error Messages
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
C-8
Recovery. Reissue the command with the correct IP address.
TCPIPV6 00044
Cause. The command requires that an IPv4 address is available in the system.
Effect. The command is rejected with the reason.
Recovery. Add a SUBNET with the IPv4 address to the system and reissue the
command.
TCPIPV6 00045
Cause. The IPv6 prefix specified is not valid.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with a correct IPv6 prefix.
TCPIPV6 00046
Cause. The command is rejected because of an invalid IPv6 route destination or
gateway address.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with a correct IPv6 route destination or gateway
address.
TCPIPV6 00047
Cause. The system was configured to operate in IPv4 mode only and a command for
INET6 mode was received.
Effect. The command is rejected with the reason.
Recovery. Reconfigure the NonStop TCP/IPv6 subsystem in INET6 or DUAL mode
and reissue the command.
TCPIPV6 E00044 This command requires IPv4 address to be
configured.
TCPIPV6 E00045 The IPv6 prefix specified in the command is
invalid.
TCPIPV6 E00046 The IPv6 route destination or gateway address
is invalid.
TCPIPV6 E00047 The system is not configured to operate in
IPv6 mode.