TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Error Messages
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
C-9
TCPIPV6 00048
Cause. The command is rejected because:
•
The system was already configured with IPv6 SUBNETs and cannot be changed to
IPv4-only mode.
•
The system was already configured with IPv4 SUBNETs and cannot be changed to
IPv6-only mode.
Effect. The command is rejected with the reason.
Recovery. For a system already configured with IPv6 SUBNETs that tries to switch to
IPv4-only mode, IPv6 for all the SUBNETs should be disabled first. Use the ALTER
SUBNET subnet, FAMILY INET6, IPV6 DOWN command to disable IPv6 for the
SUBNETs and then reissue the command. For a system already configured with IPv4
SUBNETs that tries to switch to IPv6-only mode, all the IPv4 SUBNETs should be
deleted and the system reconfigured for INET6 or DUAL mode.
TCPIPV6 00049
Cause. The command is rejected because the SUBNET is not configured or enabled
for IPv6.
Effect. The command is rejected with the reason.
Recovery. Enable the SUBNET for IPv6 operation and then reissue the command.
TCPIPV6 00050
Cause. The command is rejected because of one of these causes:
•
Multiple routes created with the ALLROUTES ON attribute resulted in the generated
route names conflicting with an existing route name.
•
Multiple routes created with the ALLROUTES ON attribute resulted in one of the
generated route name exceeding the eight-character limit.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with a correct route name.
TCPIPV6 E00048 Switching the mode is not allowed with the
current configuration.
TCPIPV6 E00049 The command is not allowed with the current
subnet configuration.
TCPIPV6 E00050 The route name is invalid with the issued
command.