TCP/IPv6 Configuration and Management Manual (G06.24+)

SCF Error Messages
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
C-10
TCPIPV6 00051
Cause. The command was rejected because of one of these causes:
•
Multiple entries with the ALLENTRY ON attribute resulted in the one or more
generated entry names conflicting with an existing entry name.
•
Multiple entries created with the ALLENTRY ON attribute specified in the command
resulted in one of the generated entry names exceeding the eight-character limit.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with a correct entry name.
TCPIPV6 00054
Cause. The ADD SUBNET command was rejected because many different logical-
network partitions exist in the system.
Effect. The ADD SUBNET command is not performed.
Recovery. Reissue the command using an existing partition.
TCPIPV6 00055
Cause. The ADD SUBNET command was rejected because the LNP list does not
match an existing LNP entry.
Effect. The ADD SUBNET command is not performed.
Recovery. Reissue the command using an existing partition.
TCPIPV6 00056
Cause. The ADD SUBNET command was rejected because the LNP list has more
than two names.
Effect. The ADD SUBNET command is not executed.
TCPIPV6 E00051 The entry name is invalid with the issued
command.
TCPIPV6 E00054 Too many logical network partions, maximum 64.
TCPIPV6 E00055 TCP6SAM name mismatch with existing LNP.
TCPIPV6 E00056 Too many TCP6SAM names in LNP list, maximum of
2 allowed.