TCP/IPv6 Configuration and Management Manual (G06.24+)

Quick Start
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
1-21
IVA. Prepare to Start the Applications (Without LNP)
3. Issue the TACL OBEY command on the TCPIPUP command file while running as
the super ID user:
4. Go to IVA. Prepare to Start the Applications (Without LNP).
IVA. Prepare to Start the Applications (Without
LNP)
Applications that use NonStop TCP/IPv6 require a TCP6SAM process to use instead
of a NonStop TCP/IP process. This subsection shows you how to configure and start a
TCP6SAM process.
1. Start the TCP6SAM process by issuing the following TACL RUN command:
2. Go to VA. Start the Applications (Without LNP) on page 1-22.
IVB. Prepare to Start the Applications (With
LNP)
Applications that use NonStop TCP/IPv6 require a TCP6SAM process to use as a
transport-service provider. If you have configured an LNP environment, you must add
TCP6SAM processes for each of the partitions, including the default partition. This step
shows you how to start TCP6SAM processes for the SUBNETs.
1. Start the TCP6SAM processes by issuing these TACL RUN commands:
>OBEY TCPIPUPA
Note. Before you start your applications, consider whether you want to use round-robin
filtering. See Round-Robin Filtering
on page 2-7 and Section 3, Maximize the Benefit of the
NonStop TCP/IPv6 Architecture.
> TCP6SAM/NAME $ZSAM2, TERM $ZHOME, OUT $ZHOME, NOWAIT, CPU
0/1
Note. Before you start your applications, consider whether you want to use round-robin
filtering. See Round-Robin Filtering on page 2-7, Section 3, Maximize the Benefit of the
NonStop TCP/IPv6 Architecture and Section 5, Example Illustrations and Adding Features to
the Basic Configuration.
> TCP6SAM/NAME $ZSAM1, TERM $ZHOME, OUT $ZHOME, NOWAIT,CPU
0/1
> TCP6SAM/NAME $ZSAM2, TERM $ZHOME, OUT $ZHOME,
NOWAIT, CPU 0/1
> TCP6SAM/NAME $ZSAM3, TERM $ZHOME, OUT $ZHOME,
NOWAIT, CPU 0/1