TCP/IPv6 Configuration and Management Manual (G06.24+)

Quick Start
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-008
1-24
VI. Add More Features
c. Start the Telserv process by entering the TACL RUN command:
5. Start the LISTNER process for the second indexed LNP.
a. ALTER the DEFINE to establish the TCP6SAM process name as the transport-
service provider for a LISTNER process in the second indexed LNP by
entering the TACL command:
b. Start the LISTNER process by entering the TACL RUN command:
6. Start the Telserv process for the second indexed LNP.
a. Add a PARAM to establish the TCP6SAM process name as the transport-
service provider for a Telserv process in the first indexed LNP by entering the
TACL command:
b. Add a PARAM to cause Telserv to use the same process going out as coming
in by entering the TACL command:
c. Start the Telserv process by entering the TACL RUN command:
VI. Add More Features
For examples of adding more features to the basic configurations shown in this
section, see Adding More Features on page 5-7. Specifically, see:
•
Add Routes on page 5-7
•
Specify IPv6 Addresses on page 5-7
•
Configure the Basic Subsystem for INET6 Mode on page 5-8
•
Round-Robin Filtering on page 2-7
•
Configure the ND6HOSTD Process for Address Resolution on page 6-19
TELSERV/TERM $ZHOME, OUT $ZHOME, NAME $ZTN1, CPU 0, NOWAIT,
PRI 170/ -BACKUPCPU 1
>ALTER DEFINE =TCPIP^PROCESS^NAME, CLASS MAP, FILE $ZSAM3
>LISTNER/TERM $ZHOME, OUT $ZHOME, NAME $LSN2, CPU 0, NOWAIT,
PRI 160/1 $SYSTEM.ZTCPIP.PORTCONF
>PARAM TCPIP^PROCESS^NAME $ZSAM3
PARAM ZTNT^TRANSPORT^PROCESS^NAME $ZSAM3
TELSERV/TERM $ZHOME, OUT $ZHOME, NAME $ZTN2, CPU 0, NOWAIT,
PRI 170/ -BACKUPCPU 1