TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

Manage the NonStop TCP/IPv6 Subsystem
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
6-20
Configure the ND6HOSTD Process for Address
Resolution
NAME $name Specifies the process name, as recognized by TACL.
$name cannot exceed three characters (after the dollar
sign). This is because the two-digit processor number is
appended to the process name.
The recommended value is $ZHD.
OUTFILE $device Specifies the output file or process name sent to this
process (in the startup message) when it is started.
$ZHOME should be specified for $device.
PRIORITY n Specifies the priority to use when starting this process.
The range is 1 through 199. If this attribute is not
specified, the priority is the same as the current SCF
session minus 1.
The recommended value for n is 180.
PROGRAM
[[$vol].subvol.]nd6hostd
Specifies the program object file for this process to use
when started.
If you specify the SYSTEM subvolume, SCF searches for
the file first on the SYSTEM subvolume and then on the
current SYSnn subvolume.
nd6hostd is the name of the object file for the process.
The recommended value is $system.system.nd6hostd.