TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
8-9
NonStop TCP/IPv6 SCF Commands
The summary states supported by the NonStop TCP/IPv6 subsystem are STARTED,
STARTING, and STOPPED. Table 8-3 shows the states for each object.

In the STARTED summary state, the object is available for data transfer.

In the STOPPED summary state, the object is defined (that is, the object exists)
but it is not available for data transfer. The STOPPED summary state is not
applicable to the PROCESS object. If the PROCESS object is not STARTED, it is
undefined (that is, the process does not exist).

In the STARTING summary state, the object has been initialized and is attempting
to start.
NonStop TCP/IPv6 SCF Commands
This subsection contains these information:

A table describing the Subsystem Control Facility (SCF) commands supported by
the NonStop TCP/IPv6 subsystem and the object types supported for each
command.

Detailed information on object specification syntax.

These detailed information about each SCF command:

A description of the command function.

The command syntax.

The object specification, which shows the supported object types and object
names.

Descriptions, by object type, of the attributes.

Considerations you should be aware of before using the command.

Command examples.
Table 8-3. Object Summary States
Object STOPPED STARTED STARTING
ENTRY X
null
PROCESS X
MON X
ROUTE X X
SUBNET X X X